tc4w66f/fu 2007-11-01 1 toshiba cmos digital integrat ed ci rcuit silicon monolithic tc4w66f,tc4w66fu dual bilateral switch the tc4w66 contains two independence circuits of bidirectional switches. when control input cont is set to ?h? level, the impedance between input and output of the switch becomes low and when it is set to ?l? level, the switch becomes high. this can be applied for switching of analog signals and digital signals. features ? on-resistance, r on 250 (typ.) ................... v dd ? v ss = 5 v 110 (typ.) ................... v dd ? v ss = 10 v 70 (typ.)..................... v dd ? v ss = 15 v ? off-resistance, r off r off (typ.) > 10 9 absolute maximum ratings characteristics symbol rating unit dc supply voltage v dd v ss ? 0.5 to v ss + 20 v control input voltage v c in v ss ? 0.5 to v dd + 0.5 v switch i/o voltage v i/o v ss ? 0.5 to v dd + 0.5 v power dissipation p d 300 mw potential difference across i/o during on v i -v o 0.5 v control input current i c in 10 ma operating temperature range t opr ?40 to 85 c storage temperature t stg ?65 to 150 c lead temp./time t l 260c/10 s note: using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operat ing temperature/current/voltage, etc. ) are within the absolute maximum ratings and the operating ranges. please design the appropriate reliability upon reviewing the toshiba semiconductor reliability handbook (?handling precautions?/?derating concept and methods?) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). marking tc4w66f tc4w66fu tc4w66f tc4w66fu weight sop8-p-1.27: 0.05 g (typ.) ssop8-p-0.65: 0.02 g (typ.)
tc4w66f/fu 2007-11-01 2 logic diagram (1/2 tc4w66f) pin assignment (top view) truth table control impedance between in/out-out/in (note 1) h 0.5 to 5 10 2 l >10 9 note 1: see static electrical characteristics. operating ranges (v ss = 0 v) characteristics symbol test condition min typ. max unit dc supply voltage v dd ? 3 ? 18 v input/output voltage v dd /v out ? 0 ? v dd v static electrical characteristics (in case not specifically appointed, v ss = 0 v) ta = ? 40c ta = 25c ta = 85c characteristics symbol test circuit test condition v dd (v) min max min typ. max min max unit control input high voltage v ih ? ? i is ? = 10 a 5 10 15 3.5 7.0 11.0 ? ? ? 3.5 7.0 11.0 2.75 5.50 8.25 ? ? ? 3.5 7.0 11.0 ? ? ? v control input low voltage v il ? ? i is ? = 10 a 5 10 15 ? ? ? 1.5 3.0 4.0 ? ? ? 2.25 4.5 6.75 1.5 3.0 4.0 ? ? ? 1.5 3.0 4.0 v on-state resistance r on ? 0 < = v is < = v dd r l = 10 k 5 10 15 ? ? ? 800 210 140 ? ? ? 290 120 85 950 250 160 ? ? ? 1200 300 200 on-state resistance (between any 2 switches) r on ? ? 5 10 15 ? ? ? ? ? ? ? ? ? 10 6 4 ? ? ? ? ? ? ? ? ? input/output leakage current i off ? v in = 18 v, v out = 0 v v in = 0 v, v out = 18 v 18 18 ? ? 100 100 ? ? 0.1 0.1 100 100 ? ? 1000 1000 na quiescent device current i dd ? v in = v dd , v ss * 5 10 15 ? ? ? 0.25 0.5 1.0 ? ? ? 0.001 0.001 0.002 0.25 0.5 1.0 ? ? ? 7.5 15 30 a h level i ih ? v ih = 18 v 18 ? 0.1 ? 10 ? 5 0.1 ? 1.0 input current l level i il ? v il = 0 v 18 ? ? 0.1 ? ? 10 ? 5 ?0.1 ? ? 1.0 a
tc4w66f/fu 2007-11-01 3 dynamic electrical characteristics (ta = 25c, v ss = 0 v, c l = 50 pf) characteristics symbol test circuit test condition v ss (v) v dd (v) min typ. max unit phase difference between input to output i-o ? c l = 50 pf 0 0 0 5 10 15 ? ? ? 15 8 5 40 20 15 ns propagation delay time (control-out) t pzl t pzh ? r l = 1 k c l = 50 pf 0 0 0 5 10 15 ? ? ? 55 25 20 120 40 30 ns propagation delay time (control-out) t plz t phz ? r l = 1 k c l = 50 pf 0 0 0 5 10 15 ? ? ? 45 30 25 80 70 60 ns max control input repetition rate f max (c) ? r l = 1 k c l = 50 pf 0 0 0 5 10 15 ? ? ? 10 12 12 ? ? ? mhz ? 3db cutoff frequency f max (i-o) ? r l = 1 k c l = 50 pf (note 1) ?5 5 ? 30 ? mhz total harmonic distortion ? ? r l = 10 k f = 1 khz (note 2) ?5 5 ? 0.03 ? % ? 50db feed through frequency ? ? r l = 1 k (note 3) ?5 5 ? 600 ? khz ? 50db crosstalk frequency ? ? r l = 1 k (note 4) ?5 5 ? 1 ? mhz crosstalk (control-out) ? ? r in = 1 k r out = 10 k c l = 15 pf 0 0 0 5 10 15 ? ? ? 200 400 600 ? ? ? mv ? control input ? 5 7.5 input capacitance c in ? switch i/o ? 10 ? pf feed through capacitance c in-out ? ? ? 0.5 ? pf note 1: since wave of 2.5 v p-p shall be used for v is and the frequency of 20 ? og 10 is os v v = ? 3db shall be f max . note 2: v is shall be sine wave of 2.5 v p-p . note 3: sine wave of 2.5 v p-p shall be used for v is and the frequency of 20 ? og 10 is out v v = ? 50db shall be feed-through. note 4: sine wave of 2.5 v p-p shall be used for v is and the frequency of 20 ? og 10 is out v v = ? 50db shall be crosstalk.
tc4w66f/fu 2007-11-01 4 1. t plh , t phl i/o-o/i 2. t pzl , t pzh , t plz , t phz control-o/i 3. r on 4. f max (c)
tc4w66f/fu 2007-11-01 5 5. crosstalk (switch i/o) 6. crosstalk (control input) 7. total harmonic distortion, f max (i/o-o/i), feedthrough (switch off) 0 v 2.5 v ? 2.5 v f 1 i/o in.
tc4w66f/fu 2007-11-01 6 package dimensions weight: 0.05 g (typ.)
tc4w66f/fu 2007-11-01 7 package dimensions weight: 0.02 g (typ.)
tc4w66f/fu 2007-11-01 8 restrictions on product use ? toshiba corporation, and its subsidiaries and affiliates (collect ively ?toshiba?), reserve the right to make changes to the in formation in this document, and related hardware, software an d systems (collectively ?product?) without notice. ? this document and any information herein may not be reproduc ed without prior written permission from toshiba. even with toshiba?s written permission, reproduc tion is permissible only if reproducti on is without alteration/omission. ? though toshiba works continually to improve product?s quality a nd reliability, product can malfunction or fail. customers are responsible for complying with safety standards and for prov iding adequate designs and safeguards for their hardware, software and systems which minimize risk and avoid situat ions in which a malfunction or failure of product could cause loss of human life, b odily injury or damage to property, including data loss or corruption. before customers use the product, create designs including the product, or incorporate the product into their own applications, cu stomers must also refer to and comply with (a) the latest ve rsions of all relevant toshiba information, including without limitation, this document, the specifications, the data sheets and application notes for product and the precautions and condi tions set forth in the ?toshiba se miconductor reliability handbook? and (b) the instructions for the application with which the product will be us ed with or for. customers are solely responsible for all aspe cts of their own product design or applications , including but not limited to (a) determining the appropriateness of the use of this product in such design or applications; (b) evaluating and determining the applicability of any information contained in this document, or in c harts, diagrams, programs, algorithms, sample application circuits, or any other referenced documents; and (c) validating all operatin g parameters for such designs and applications. toshiba assumes no liability for customers? product design or applications. ? product is intended for use in general el ectronics applications (e.g., computers, personal equipment, office equipment, measur ing equipment, industrial robots and home electroni cs appliances) or for specif ic applications as expre ssly stated in this document . product is neither intended nor warranted for use in equipment or systems that require extraordinarily high levels of quality a nd/or reliability and/or a malfunction or failure of which may cause loss of human life, bodily injury, serious property damage or se rious public impact (?unintended use?). unintended use includes, without limitation, equipment used in nuclear facilities, equipment used in the aerospace industry, medical equipment, equipment used for automobiles, trains, ships and other transportation, traffic s ignaling equipment, equipment used to control combustions or explosions, safety devices, elevat ors and escalators, devices related to el ectric power, and equipment used in finance-related fields. do not use product for unintended use unless specifically permitted in thi s document. ? do not disassemble, analyze, reverse-engineer, alter, modify, translate or copy product, whether in whole or in part. ? product shall not be used for or incorporated into any products or systems whose manufacture, use, or sale is prohibited under any applicable laws or regulations. ? the information contained herein is presented only as guidance for product use. no re sponsibility is assumed by toshiba for an y infringement of patents or any other intellectual property rights of third parties that may result from the use of product. no license to any intellectual property right is granted by this documen t, whether express or implied, by estoppel or otherwise. ? absent a written signed agreement, except as provid ed in the relevant terms and conditions of sale for product, and to the maximum extent allowable by law, toshiba (1) assumes no liability whatsoever, including without limitation, indirect, co nsequential, special, or incidental damages or loss, including without limitation, loss of profit s, loss of opportunities, business interruption and loss of data, and (2) disclaims any and all express or implied warranties and conditions related to sale, use of product, or information, including warranties or conditions of merchantability, fitness for a particular purpose, accuracy of information, or noninfringement. ? do not use or otherwise make available product or related soft ware or technology for any military purposes, including without limitation, for the design, development, use, stockpiling or manufacturing of nuclear, chemical , or biological weapons or missi le technology products (mass destruction w eapons). product and related software and technology may be controlled under the japanese foreign exchange and foreign trade law and the u.s. expor t administration regulations. ex port and re-export of product or related software or technology are strictly prohibited exc ept in compliance with all applicable export laws and regulations. ? please contact your toshiba sales representative for details as to environmental matters such as the rohs compatibility of pro duct. please use product in compliance with all applicable laws and regula tions that regulate the inclusion or use of controlled subs tances, including without limitation, the eu rohs directive. toshiba assumes no liability for damages or losses occurring as a result o f noncompliance with applicable laws and regulations.
|
